NASA Logo, National Aeronautics and Space Administration
NASA Space Science Data Coordinated Archive Header

Lunar Orbiter 1

NSSDCA/COSPAR ID: 1966-073A

Description

The Lunar Orbiter 1 spacecraft was designed primarily to photograph smooth areas of the lunar surface for selection and verification of safe landing sites for the Surveyor and Apollo missions. It was also equipped to collect selenodetic, radiation intensity, and micrometeoroid impact data. The spacecraft was placed in an Earth parking orbit on 10 August 1966 at 19:31 UT and injected into a cislunar trajectory at 20:04 UT. The spacecraft experienced a temporary failure of the Canopus star tracker (probably due to stray sunlight) and overheating during its cruise to the Moon. The star tracker problem was resolved by navigating using the Moon as a reference and the overheating was abated by orienting the spacecraft 36 degrees off-Sun to lower the temperature.

Lunar Orbiter 1 was injected into an elliptical near-equatorial lunar orbit 92.1 hours after launch. The initial orbit was 189.1 km x 1866.8 km and had a period of 3 hours 37 minutes and an inclination of 12.2 degrees. On 21 August perilune was dropped to 58 km and on 25 August to 40.5 km. The spacecraft acquired photographic data from August 18 to 29, 1966, and readout occurred through September 14, 1966. A total of 42 high resolution and 187 medium resolution frames were taken and transmitted to Earth covering over 5 milliom square km of the Moon's surface, accomplishing about 75% of the intended mission, although a number of the early high-res photos showed severe smearing. It also took the first two pictures of the Earth ever from the distance of the Moon. Accurate data were acquired from all other experiments throughout the mission. Orbit tracking showed a slight "pear-shape" to the Moon based on the gravity field and no micrometeorite impacts were detected. The spacecraft was tracked until it impacted the lunar surface on command at approximately 6.70 degrees N latitude, 162 degrees E longitude on the Moon's far side on October 29, 1966 at 13:30 UT on its 577th orbit. The early end to the nominal one year mission was due to the small amount of remaining attitude control gas and other deteriorating conditions and was planned to avoid transmission interference with Lunar Orbiter 2.

Spacecraft and Subsystems

The main bus of the Lunar Orbiter had the general shape of a truncated cone, 1.65 meters tall and 1.5 meters in diameter at the base. The spacecraft was comprised of three decks supported by trusses and an arch. The equipment deck at the base of the craft held the battery, transponder, flight progammer, inertial reference unit (IRU), Canopus star tracker, command decoder, multiplex encoder, traveling wave tube amplifier (TWTA), and the photographic system. Four solar panels were mounted to extend out from this deck with a total span across of 3.72 meters. Also extending out from the base of the spacecraft were a high gain antenna on a 1.32 meter boom and a low gain antenna on a 2.08 meter boom. Above the equipment deck, the middle deck held the velocity control engine, propellant, oxidizer and pressurization tanks, Sun sensors, and micrometeoroid detectors. The third deck consisted of a heat shield to protect the spacecraft from the firing of the velocity control engine. The nozzle of the engine protruded through the center of the shield. Mounted on the perimeter of the top deck were four attitude control thrusters.

Power of 375 W was provided by the four solar arrays containing 10,856 n/p solar cells which would directly run the spacecraft and also charge the 12 amp-hr nickel-cadmium battery. The batteries were used during brief periods of occultation when no solar power was available. Propulsion for major maneuvers was provided by the gimballed velocity control engine, a hypergolic 100-pound-thrust Marquardt rocket motor. Three-axis stabilization and attitude control were provided by four one-lb nitrogen gas jets. Navigational knowledge was provided by five Sun sensors, Canopus star sensor, and the IRU equipped with internal gyros. Communications were via a 10 W transmitter and the directional 1 meter diameter high gain antenna for transmission of photographs and a 0.5 W transmitter and omnidirectional low gain antenna for other communications. Both antennas operated in S-band at 2295 MHz. Thermal control was maintained by a multilayer aluminized mylar and dacron thermal blanket which enshrouded the main bus, special paint, insulation, and small heaters.

Results of the Lunar Orbiter Program

The Lunar Orbiter program consisted of 5 Lunar Orbiters which returned photography of 99% of the surface of the Moon (near and far side) with resolution down to 1 meter. Altogether the Orbiters returned 2180 high resolution and 882 medium resolution frames. The micrometeoroid experiments recorded 22 impacts showing the average micrometeoroid flux near the Moon was about two orders of magnitude greater than in interplanetary space but slightly less than the near Earth environment. The radiation experiments confirmed that the design of Apollo hardware would protect the astronauts from average and greater-than-average short term exposure to solar particle events. The use of Lunar Orbiters for tracking to evaluate the Manned Space Flight Network tracking stations and Apollo Orbit Determination Program was successful, with three Lunar Orbiters (2, 3, and 5) being tracked simultaneously from August to October 1967. The Lunar Orbiters were all eventually commanded to crash on the Moon before their attitude control gas ran out so they would not present navigational or communications hazards to later Apollo flights. The Lunar Orbiter program was managed by NASA Langley Research Center and involved building and launching 5 spacecraft to the Moon at a total cost of $163 million.

Alternate Names

  • Lunar Orbiter-A
  • 02394

Facts in Brief

Launch Date: 1966-08-10
Launch Vehicle: Atlas-Agena D
Launch Site: Cape Canaveral, United States
Mass: 385.6 kg
Nominal Power: 375.0 W

Funding Agency

  • NASA-Office of Space Science Applications (United States)

Disciplines

  • Planetary Science
  • Space Physics

Additional Information

Questions or comments about this spacecraft can be directed to: Dr. David R. Williams.

 

Personnel

NameRoleOriginal AffiliationE-mail
Mr. Isidore G. RecantProject ManagerNASA Langley Research Center 
Mr. Leon J. KosofskyGeneral ContactNASA Headquarters 

Selected References

Lunar Orbiter 1 - photographic mission summary, NASA-LRC, CR-782, Langley Sta., Va., Apr. 1967.

Rowan, L. C., Orbiter observations of the lunar surface, Am. Astron. Soc., 66-180, Wash., DC, Dec. 1966.

Levin, E., et al., Lunar Orbiter missions to the moon, Sci. Amer., 218, 58-66, May 1968.

Lunar Orbiter I preliminary results, NASA, SP-197, Washington, DC, 1969.

Byers, B. K., Destination Moon: A history of the Lunar Orbiter program, NASA Headquarters, TM X-3487, Wash, DC, 1977.

Other Lunar Orbiter Information/Data at NSSDCA

Lunar Orbiter 1
Lunar Orbiter 2
Lunar Orbiter 3
Lunar Orbiter 4
Lunar Orbiter 5
Lunar Orbiter Home Page

Related Information/Data at NSSDCA

Lunar Exploration Home Page
Moon Home Page
Moon Fact Sheet

Other Sources of Lunar Orbiter Information/Data

USGS Digitized Lunar Orbiter Images
Destination Moon: A History of the Lunar Orbiter Program
Lunar Orbiter Photographic Atlas of the Moon
Unmanned Space Project Management - Surveyor and Lunar Orbiter

[USA.gov] NASA Logo - nasa.gov